GEMO

Home | About GEMO | Order online | Contact us 

You are Here: Fittings
P&E Flow technology is fully committed and complies with the implementation of regulations involving quality, environment and safety.  

GEMO FITTINGS
Sanitary ASME
S-line fittings
Weld fittings
Sanitary DIN
Fittings DIN11852/DIN11850
Clamp Union DIN32676
Unions DIN11850/DIN11851
Sanitary ISO2037
ISO2037 fittings
Clamp union ISO2037
SMS Unions

GEMO

 

Sanitary range fittings
GEMO Sanitary fluid handing products, Sanitary range tubes and fittings this product range provides a wide range of fittings with internal surface finishes that have a Roughness overage(Ra)of +0.4-1.6μm. Tubes and fittings in the sanitary range comply with ASME Dimension, DIN11852, DIN11850 and ISO2037.

 

 SANITARY ASME

 

 

S-line fittings The easiness that S-line fittings present as far as assembly and dismantling of process lines and equipment are concerned can not be matched. Gaskets for S-line Fittings are available in several different materials, EPDM, Silicone, FPM, and PTFE.

 

 

 

Weld fittings give processors the highest degree of corrosion resistance and sanitation available. Their streamlined design, flush joints and butt-weld assembly provides full, unrestricted flow for truly hygienic, permanent welded systems.

 

 SANITARY DIN

 

 

Fittings DIN11852/DIN11850 The hygienic Tubes, bends, Tee, Reducers, And Clamp Union of GEMO are strictly according to Germany DIN11850, DIN32676 Standard, Gaskets for Clamp Fittings are available in several different materials, EPDM, Silicone, FPM, and PTFE.

 

 

 

Clamp Union DIN32676 The hygienic Tubes, bends, Tee, Reducers, And Clamp Union of GEMO are strictly according to Germany DIN11850, DIN32676 Standard, Gaskets for Clamp Fittings are available in several different materials, EPDM, Silicone, FPM, and PTFE.

 

 

 

Unions DIN11850/DIN11851 The DIN union is the German standard hygienic fitting, A complete range of DIN fittings are offered in order to meet the needs of imported equipment from Europe. These fittings are used for hygienic purposes and offer a leak-free joint obtained with a rubber seal. Available in sizes DN15mm to DN150mm.

 

 SANITARY ISO2037

 

 

ISO 2037 fittings International standard ISO2037 was prepared by technical committee ISO/TC5, These are stainless steel tubes and stainless steel fittings that are commonly used all over Europe.

 

 

Clamp union ISO2037 are named from Swedish Dairy Standard ( Svensk MeieriStandard ) There are a multitude of variants in pipe-clips and clamps and couplings and unions that is commonly used all over Europe.

 

 

SMS union is the Swedish standard hygienic fitting. It can be recognized by the round slotted nut and square section joint ring. Probably the most widely used hygienic fitting worldwide, there is always a small crevice between the face of the male spigot and the liner Therefore, it facilitates the removal of sections of pipe work without the need of to disturb adjacent sections.

 
Change language

Copyright © by P&E Flow technology. All Rights reserved | Terms and Conditions | Privacy Policy | Log In